|
|
| 700R4
TV wire
connector link location |
2004R
TV wire
connector link location |
 |
 |
| Step
1 |
  |
The TV cable
is connected to the passenger side of Th-2004R and Th-700R4 transmissions
at the locations shown in the above pictures. Same side as your
dipstick. The picture at the far left shows the wire link and the
TV cable to case seal. This seal must be placed into the transmission
before installation, not onto the end of the TV cable housing!
The wire link will be inserted into the hole of the connector at
the transmission end of the TV cable. (See closest picture at left)
|
| Step
2 |
| We
install a new TV cable seal into every transmission we build. A new
seal is also provided with new TV cables. With the transmission in
the vehicle, it's very difficult to see if a seal is already installed
into the case. Don't try to install two seals into the same
hole! The proper method for installing the TV cable is to
remove the seal from the end of the TV cable, install one into the
case, lube the end of the TV cable housing then slide this freshly
lubricated housing into the seal in the case. Steps three and four
will take you through this picture by picture. |
  |
| Step
3 |
  |
Slide
the bent end of the link through the attachment hole at the end of
the TV cable. Gently pull on the opposite end of the TV cable (carburetor/fuel
injection end) of the TV cable while feeding the transmission end
of the cable housing down into the transmission seal. Be sure the
wire link doesn't slip out while performing this procedure. |
| Step
4 |
|
Start the end of the cable housing into the rubber seal and push it
all the way in using a twisting motion until it's completely seated
flush with the case. Now line up the bolt hole on the cable housing
with the bolt hole on the transmission case. Install and tighten the
bolt. Use caution not to over tighten and break the housing. |
 |
|
