|
|
| NOTE |
|
In the
instructions below, we use an LS1 setup, so your setup may not
look the same. However, the instructions still apply to any setup
you may have |
| Step 1 |
  |
Now
that you have your braided TV cable installed on your bracket, you
have to adjust it. Start by losening the back adjuster nut using
a 10mm (1/2") wrench. At the same time, push on the cable housing
as to move it forward. You will want to keep moving it forward until
you see the pressures on your pressure gauge stop decreasing.
|
| Step 2 |
|
Start
to tighten the back adjuster nut as to move it back until you see
a 2-4lbs increase on your pressure gauge. Once you have this increase,
tighten the front adjuster nut and secure the cable in this position.
|
  |
|
